Skip to content

pH and ORP Sensor

$0.00

SKU: N/A Category:
Probe Configuration

RH71 = Inline Twist Lock, RH76 = Submersible, RH77 = Hot Tap or Sanitary

Measurement Type

PH = pH Sensor, ORP = ORP Sensor

Signal Type

A = Analog, D = Digital

Application

0 = General Purpose, 1 = High Temperature, 2 = Ultra High Temperature, 3 = Abrasive Slurries and High Viscosity, 4 = Acids, Fluorides and HF Solutions, 5 = Pulp and Paper Slurry Type Processes, 6 = Dissolved Sulfide (H2S, HS and S2), 7 = Aggressive Dissolved Ammonia and Chlorine Gas and Volatile Organic Solvents, 9 = Saturated Sodium (Brine) Samples

Temperature Compensation

AT = ACCU-TEMP Temperature Sensor, 1 = 3000 Ohm Balco RTD, 2 = 301 Ohm RTD, 3 = 1000 Ohm Platinum RTD, 4 = 100 Ohm Platinum RTD

Protection Tines

NT = No Glass Protective Tines on Tip, 2T = 2 Each Glass Protective Tines on Tip, 4 = 4 Each Glass Protective Tines on Tip

Grounding Options

NS = No Solution Ground, SG = 316 Stainless Steel Solution Ground Addition, PG = Platinum Solution Ground Addition

Process Junction

DJ = Double Junction Standard, TJ = Adds Another Layer of Junction Protection to the Standard Double

Cable Length

0 = Standard Cable Length, 10 = Increase the Standard Cable Length 10ft, 20 = Increase the Standard Cable Length 20ft, 30 = Increase the Standard Cable Length 30ft

Cable Protection

OO = No Protection Tube, VT = Vinyl Tubing Encapsulates the Sensor Cabling, BC = Shielded and Braid Reinforced Blue Cable

Analog with Preamp

NA = Not Applicable, PREAMP = Analog Sensor with Preamp

Specials

NA = Not Applicable, DR = Extreme Dehydration Resistance (Digital Probe Only)

Hardware

NA = No Hardware, SS = SS Hot Tap with 316SS 1 1/4 Compression Fitting (RH77 Only), TI = Titanium Hot Tap with 316SS 1 1/4 Compression Fitting (RH77 Only), TR = 316 SS Sanitary TRI-CLOVER 1.5", 2.0" and 2.5" Sensor Holders

Reviews

There are no reviews yet.

Be the first to review “pH and ORP Sensor”

Your email address will not be published. Required fields are marked *